Home Products Back Gauge Belt Polar 115 with V Bottom Slot Covering

Back Gauge Belt Polar 115 with V Bottom Slot Covering

US$315.00

41 in stock

SKU: PRI030BGBVP Categories: , Tags: , ,

Product Description

Back Gauge Belt Polar 115 with V Bottom Slot Covering

PL-3231113

For a Polar 115 from serial number 5531400 up to 6432006 it would be our part number PPEGB431.
For a Polar 115 after serial number 6432006 it would be our part number PPEGB436.

Part Number: PPEGB431
Slot covering belt or tape for Polar paper cutters.
This green belt is equivalent to, and a direct replacement for, the original Polar part number 3231113.
It is an aftermarket belt which is made from the same material as the original.
It contains the center “V” guide which is fused to the belt.
This belt measures 60 mm wide (2 3/8″ wide) by 1.25mm thick (.050″ thick).
The cogged center “V” guide is 10 mm wide. As shown in the photo, both ends are square cut.

Part Number: PPEGB436
Slot covering belt or tape for many of the Polar 115 S, 115 E, 115 ES, 115 ED, 115 X, and 115 XT paper cutters. This belt does not fit cutters with a serial number before 6403101. (Always check your parts book for the original part number before ordering. There are many length variations with these belts. The original part number is usually located on page 20.22 of the Polar parts book.)
This flexible green table slot “cover band” or belt is equivalent to, and a direct replacement for, the original Polar part number 033961, 033961N, ZA3.033961, and ZA3.033961N. It is an aftermarket belt which is made from the same material as the original. It contains the center “V” guide which is fused to the belt.
Measures 60 mm wide (2 3/8″ wide) by 1.25mm thick (.050″ thick). The width at the base of the cogged center “V” guide is 10 mm wide. As shown in the photo, one end has the mounting slots cut out, the other end has the two mounting grommets installed.

Additional information

Weight.1 lbs
Dimensions3.0 × .03 × 3.0 in

Product Enquiry