Back Gauge Belt Polar 115 with V Bottom Slot Covering

Description

Back Gauge Belt Polar 115 with V Bottom Slot Covering

• PL-3231113
• For a Polar 115 from serial number 5531400 up to 6432006 it would be our part number PPEGB431.
• For a Polar 115 after serial number 6432006 it would be our part number PPEGB436.

Part Number: PPEGB431

• Slot covering belt or tape for Polar paper cutters.
• This green belt is equivalent to, and a direct replacement for, the original Polar part number 3231113.
• This aftermarket belt uses the same material as the original.
• It contains the center “V” guide, and the manufacturer fuses it to the belt.
• This belt measures 60 mm wide (2 3/8″ wide) by 1.25mm thick (.050″ thick).
• The cogged center “V” guide is 10 mm wide. As shown in the photo, both ends are square cut.

Part Number: PPEGB436

• Slot covering belt or tape for many of the Polar 115 S, 115 E, 115 ES, 115 ED, 115 X, and 115 XT paper cutters.
• This belt does not fit cutters with a serial number before 6403101. (Always check your parts book for the original part number before ordering. There are many length variations with these belts.
• The original part number is usually located on page 20.22 of the Polar parts book.)
• This flexible green table slot “cover band” or belt is equivalent to, and a direct replacement for, the original Polar part number 033961, 033961N, ZA3.033961, and ZA3.033961N.
• This aftermarket belt uses the same material as the original.
• It contains the center “V” guide which is fused to the belt.
• Measures 60 mm wide (2 3/8″ wide) by 1.25mm thick (.050″ thick).
• The width at the base of the cogged center “V” guide is 10 mm wide.
• As shown in the photo, one end has the mounting slots cut out, the other end has the two mounting grommets installed.